Operating your Receiver
You can connect up to 7 audio/video sources to this amplifier:
Source button | Corresponding connector |
(receiver front panel) | (receiver back panel) |
- DVD | DVD IN (audio / video) |
- SAT | SAT IN (audio / video) |
- | |
- | VCR 2 IN (audio / video) |
- CD | CD IN (audio only) |
- TV | TV IN (audio only) |
- TAPE | TAPE IN (audio only) |
- FM/AM |
When a source is selected, the source name will be shown on the display.
Using the Remote to Control Additional Components
You can set your remote to control other components (like CD, TV, DVD, TAPE, etc.). What you need is to encode them in advance (not necessary for recent RCA & Proscan models).
1.Turn on the component to be programmed.
2.Look up the brand and corresponding code num- ber in the code list from page 24 to 26.
3.Press and hold the corresponding Source Button (like VCR1, VCR2, TV, DVD) on the remote while entering the code from the code list using the Number Buttons.
Example: Press DVD to select DVD as the source to the amplifier.
NOTE
1. Your receiver has a built in tuner. Just con- |
nect the appropriate antenna on the back of |
the receiver and you will be able to listen to |
radio stations. (See details in Tuner section) |
VCR1 | ON OFF | TV |
|
|
|
DVD•6 CH VCR2 AM•FM SAT•CABLE
CDTAPE
CH +
4.Release the compo- nent button, then press ON•OFF to see if the component will be
turned off.
FUNCTION
MENUCLEAR
1 2 3
4 5 6
7 8 9
INPUT•SEEKANT•FMS
0
VCR1 | ON OFF | TV |
|
|
|
DVD•6 CH VCR2 AM•FM SAT•CABLE
CDTAPE
CH +
2. Other sources can be connected to the |
above standard source. Example: you can con- |
nect a LD into the DVD inputs. |
3. Refer to the "Connecting To |
Components" section for details on connec- |
tion. |
5.If this does not work, repeat steps 3 and 4 by try- ing to use the next code (if available) listed for the brand of your component until the component responds to the remote command.
14
