RTD215 EN 6/2/07 3:36 PM Page 10
Connections and Setup
Connecting the antennas
EN | FM 75 Ω |
White
Antenna
GND
The AM and FM antennas connect to the AM and FM terminals on the system’s back panel. They must be hooked up in order to receive clear reception.
AM Loop Antenna and FM Indoor
Antenna
1.Uncoil the AM Antenna wire.
2.Press down on the Antennas tab to open the terminal.
3.Make sure the white wire on the AM loop antenna is inserted into the AM loop terminal and the other wire is inserted into the ground loop terminal.
Connecting to audiovisual equipment
VIDEO OUT
Pr
AUDIO IN
Pb
L
VIDEO
Y
R
COMPONENT VIDEO | AUX |
(REGULAR AND PROG SCAN) |
|
The jacks on the back of your receiver (shown above) and the cables shown below are used to connect to other components.
The video jacks are OUT jacks, which need to be connected to IN jacks on the TV or monitor you’re connecting to (so the video content goes
from the receiver to the screen). The audio jacks are IN jacks, which need to be connected to OUT jacks on the component you are connecting to, so the sound from the component comes into the receiver (and out through the speakers).
Video cables
Composite video cable (included)
The basic Video jack (color- coded yellow) is also referred to as composite video.
Component video cables (Pr, 
Pb, Y) (not included)
The Y, Pb, Pr jacks provide
optimum picture quality by 
separating the video signal into 
three parts. To ensure
maximum picture quality, use three
Audio cables (not included) AUDIO IN L (left) and AUDIO IN R (right)
These jacks and cables are often
audio, white=left audio).
Notes:
•If your television is a high definition television, use the unit's progressive scan output to get the highest possible video resolution. Set the Progressive Scan option in the Video menu to On. See page 20.
•If one of the devices is not working, check that all the cables have been inserted properly into the jacks.
•If your component has only one input for audio (mono), connect it to the left (white L/Mono) audio jack on the TV and don’t connect the right audio part of the cable.
2
