RCA RTS202 Connections and Setup, Accessories provided, Things to consider before you connect

Connections and Setup

Connecting AUDIO from external sources such as TV (Aux-In)

Accessories provided

EN

•	Leave enough space around the unit to
	allow adequate ventilation: 10 cm/4 inches
	on either side and above the top, and 5
	cm/2 inches at the rear.
•	The humidity of the room should not
	exceed 75%. If you have to use the unit
	outdoors, do not expose it to rain or
	splashing water. The apparatus should not
	be exposed to dripping or splashing and
	no objects filled with liquids, such as vases,
	should be placed on the apparatus.
•	Moving the unit from a cold place to a
	warm one can cause condensation on

Using AUDIO IN (AUX 1) jacks

Connect the AUDIO IN (AUX 1) jacks from the rear panel of the unit to the AUDIO OUT jacks on TV, Set Top Box, VCR or other component.

Using AUDIO IN (AUX 2) jacks

Connect the AUX IN (AUX 2) jacks on the front panel of the unit to the AUX OUT (AUDIO OUT) jacks on VCR, TV, Set Top Box or other

component.EN

Remote control and	Subwoofer
2xAAA batteries
	FM Pig-Tail
	antenna wire
External AM
loop antenna	Composite
	Video Cable

Wall Mounting Hardware

Wall-mounting hardware included to facilitate mounting of sound bar on wall. It’s recommended that mounting be carried out by a professional. Additional or alternative parts may be needed for attachment to specific types of wall construction.

Things to consider before you connect

•Ensure that the mains supply in your house complies with that indicated on the identification sticker located on the back of your unit.

•Install your unit horizontally, away from any source of heat (fireplace) or appliances creating strong magnetic or electric fields. The components of this unit are sensitive to

heat. The maximum ambient temperature

2should not exceed 35°C/95°F.

some components inside the unit. Let the

condensation disappear on its own before

turning the unit on again.

• Before moving the unit, make sure the disc

tray is empty.

• Where the mains plug or an appliance

coupler is used as a disconnect device,

the disconnect device shall remain readily

operable.

• Other important use and cleaning

information at the end of the booklet.

Connecting the antennas

Antenna

White

AM LOOP GND FM ANTENNA

The AM and FM antennas connect to the AM and FM terminals on the system’s back panel. They must be hooked up in order to receive clear reception.

AM Loop Antenna

1.Uncoil the AM Antenna wire.

2.Press down on the Antennas tab to open the terminal.

3.Make sure the white wire on the AM loop antenna is inserted into the AM loop terminal and the other wire is inserted into the ground loop terminal.

• Audio cables (color-coded in red and white) (not included) are required.

•To listen to the audio input from the connected component, press SOURCE on the main unit or AUX1/2 on the remote control to select AUX 1 or AUX 2 mode.

Connecting to your TV

Method 1 (best)

HDMI

• Connect the HDMI OUT jack on the rear of the unit to the HDMI IN jack on your TV using a HDMI cable (not included).

• Press the HDMI button on the remote control to change output signals as follows: 480p, 720p, 1080i and 1080p.

• Refer to the owner’s manual of

the connected TV as well.

• When using HDMI cable, set the HDMI Audio to PCM.

HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI licensing

LLC.

3