Using the TV, TV Channel Setting, Antenna, Auto Scan

using the TV

Connect a TV antenna or CATV cable or Satellite system to the TV antenna terminal before scanning for TV channels

Scanning for TV Channels Automatically (Only appears to the first time power on)

1.Connect the TV antenna.

2.Connect the AC power cord.

3.Press the ON/OFF button to turn on the unit.

4.Press the DVD/TV/RADIO button (the FUNCTION button on the remote control) to select TV mode.

5.Press the button to select “Yes”.

6.Press the ENTER button.

7.Press the or button to select Antenna.

8.Press the or button to select Air.

9.Press the or button to select Auto Scan.

10.Press the button to enter.

11.Press the /ENTER button.

12.The unit will immediately search all channels for those with adequate signal strength and store those channels with signals in memory. The unit will take a short minutes to finish auto scan and after this is completed, the unit will switch to the first channel found.

Picture

Audio

Time

Setup

Parental

RF CH		11
Found		0

Select	"ENTER" Adjust	MENU Return

TV Channel Setting

1.Press the TV MENU button.

2.Use the or button to select TV.

3.Use the or button to select the options (Antenna / Auto

	Scan / Auto Scan Add CH / Channel Skip / Channel No. /
	Channel Label / DTV Signal).		Picture Audio Time	Setup	Parental TV
4.	Use the or	button to make adjustment. The screen will	Antenna	Air
	change to your selected mode immediately. Press the TV		Auto Scan Add CH
			Auto Scan
	MENU button to return to the previous menu.		Channel Skip
5.	Repeat steps 2 to 4 to adjust other options.		Channel No.
5.	Repeat steps 2 to 4 to adjust other options.		Channel Label
6. To exit the MAIN MENU and return to the normal screen, press			DTV Signal
	the EXIT button on the remote control.		Select	Adjust	MENU Return
NOTE: Channel No. : 2-69 Channel for Air, 1-135 Channel for
Cable.
Antenna :		Select “Cable” to receive cable signals. Select “Air” to receive “over the air” (broadcast)
		signals.
Auto Scan :		Automatically scan all channels for those with adequate signal strength.

Auto Scan Add CH: The already-stored channels will not be cleared and the newly-scanned channels will be added.

If you have selected Cable in Antenna, then you can select Cable System (AUTO / STD / HRC / IRC) in the submenu. We recommend you pick “AUTO”. “HRC” and “IRC” are custom station frequencies used by some Cable Service Providers. “STD” refers to the standard frequencies used by many Cable Service Providers. “AUTO” will cause the product to scan all frequencies.

Channel Skip: You may switch ON/OFF the skip function of each stored channel by selecting the channel with or button (and using or button to select page if the amount of stored channels is more than 1 page), and followed with pressing the ENTER button.