The programmable clock/timer permits unattended
recording of up to four different TV programs. The
hmer is actually a small computer which will turn onthe
VCR at the time you select, record for a selected length
of time. and then turn off the VCR... all automatically
without you being there.
-You can pro_am the timer to do the--
following:
•Record aprogram on a single day up to one year
away. [NORMAL PROGRAM}
• Record aprogram at the same time Monday
through Friday. [DALLY PROGRAM]
• Record aprogram on one certain day of every
v_'eek.[WEEKLY PROGRAM}
-Things to know before you start:
• You can program the timer up to one year before
the TV program is to be recorded.
• You can correct an error in the program any time
before the last step by pressing the CLEAR button
on the remote control repeatedly until the digit to
be corrected is flashing. Then enter the correct
digit and continue the programming sequence.
Simplified Programming Instructions
1. Turn on VCR.
2. Turn on TV and tune it to the VCR channel
(channel 3 or 4_.
3. Press PROGRAM on remote hand umt_
4. Watch the display on the TV screen-it will
prompt you Lbrough the rest of the
programnung exercise.
5. Insert a cassette tape with its safety tab intact.
(Rewind the tape if necessary.)
6. Turn off the VCIL
Turn on your VCR and TV. Tune the TV to
the VCR channel (channel 3 or 4) so you'll
i] be able to see the programming display on
the TV screen.
Make sure the VCR's clock is set to the
correct time. The timer cannot record at the
right time if the clock is set incorrectly. Reset
the clock if necessary.
Press PROGRAM on the remote hand unit.
The programming "'menu" appears on the
TV screen.
TO SELECT MODE
PVSH _UM_ER SHOC_N
iI CLOCK $_r
2_ORM&L PAOGRAM
3 DAILYtV-F_ p_RA_
4 W[_Ly e_OGR_M
5 P_0_AAM REVIE_
TO END PffS_ PROGRAM
Press "2" to enter a Normal Program. "3" to
enter a Daily Program. or "4" to enter a
Weekly Program.
The display will prompt you to select a
Program Number.
_] Four program numbers are available and you
can enter different programming instructions
m each one. All four program numbers will
be flashing because none of them have been
used. If the timer has been programmed, the
number that was used will stay on instead of
flash. You must clear a program number
before the same number can be used again.
See "Clearing a Timer Program" on the next
page.
NO_._LPROOR*M_4'
$[L[CT PROG NL_MEER
TO EN_ PUS_ PRO_A_
Press a digit from ] to 4 on the remote to
select the program number you want to
program.
[31 The display will prompt you to select a
channel number.
_0_¥AL eMOG_AM ,
TFME O_ .... Press two digits for the channel to be
recorded (for example, press 0 then 4 for
channel 41.
41 The display will prompt you to enter the
recording start time.
22
C_ 0d
$T_R_ DATE - ¢__/__
TO _NO _U$_ _OG_A_
Press four digits, two for the hour and two
more for the minute. For example, press 06 0
0 for 6:00. (Always press "0" before a single-
digit hour or minute.)