Before you use the remote control unit supplied with
sour ViSR, install the batteries (instructions below). Several of the remote's buttons do the same things as buttons with the same names on the top of your VCR, and you can use whichever one is more convenient at the
moment.
The remote control has additional buttons for
controlling some of the VCR's special features, and it is
also used for setting the clock and programming the timer.
Since the remote control operates the VCR by infrared light, it is immune to electrical and sound interference. However, you must aim the remote control directly at
the VCR. There cannot be any obstructions between them.
-Batter3' InstalLation
The batteries supplied with your remote control are packed separately. Here's how to install them:
1.Turn the remote control over and remove the cover of the batter 3 compartment.
2.Insert the batteries so that their positive (+) ends contact the positive terminals in the battery'
compartment. These are marked (+) in the bottom of the compartment.
3.Replace the cover.
Remote Control
(Back View)
Battery
Compartment
/ Cover
Notes:
•Never place ans'thin_ heav_' on top of the remote control or lab" it
dentally' depress the buttons for a long time and discharge the batteries.
•Replace the batteries when the VCR fails to respond to the remote control.
•Remove the batteries from the remote control if it will not be used for a month or more. This will
prevent possible damage from battery leakage.
Location and Function of
Remote Control Buttons
POWER Button: Turns the VCR on and off. (If the
VCR is off. inserting a cassette will automatically turn it on.)
@Number Buttons (0 through 9): Select any channel (whether or not it is in the Tuner Scan List) by pressing two buttons. (Press 0 and then 8 for Channel 8.) The numbered buttons are also used for setting the clock and programming the timer.
(_ Channel • and Butlnns: Use these buttons to
select the next channel up or down programmed in the scan list.
The VCR tuner must be programmed for the Channel • and • buttons to wort:. Details are on
page 12.
PROGRAM Button: Used to set the clock and program the timer with use of the
® PAUSE Button: Pressing the PAUSE button during recording stops the tape so that nothing will be recorded. When you press the PA USE button again, recording resumes immediately.
Pressing PA USE during playback produces a stop- action picture, and pressing it again resumes normal playback. Details are on page 20.
® CLEAR Button: Used to clear incorrect information when programming the timer. Also used to clear a timer program or to reset the Tape Counter to "0000".
@DISPLAY Button: Controls
•Press once to bring normal displays to TV screen.
•Press twice to display Tape Counter and turn on counter memory.
•Press three times to remove all displays lrom TV screen.
14
