RCA VR704HF manual HOW to Find Your TV’S Video Input Channel, Video Input Channel Variations

APPENDIX: REFERENCE

HOW TO FIND YOUR TV’S

VIDEO INPUT CHANNEL

TV Button

You need to tune your TV to the Video Input Channel if you are using the VCR’s AUDIO/VIDEO OUT jacks to connect to the TV’s AUDIO/VIDEO INPUT jacks. You must select this “channel” before you can see the VCR’s menus, the cable or antenna reception, and the content that’s on a tape.

The Video Channel on TVs varies for different brands and different models. Below are some steps to try:

•If your TV brand is RCA, GE, or PROSCAN, press the TV button on the remote control that came with the VCR. Then press the INPUT button on the remote.

VCR1	ON • OFF	TV
DVD	VCR2 AUX	SAT • CABLE
MUTE		SEARCH
	CH +
L		V
O		O
V		L

				CH -
• If you have another brand of TV, consult the section,			SPEED		GO BACK
Programming The Remote, to see if the VCR’s remote
			GUIDE		INFO
control can be set to control your TV. If so, follow the
step above.				OK
If those options do not work, try the following ideas. You might
access the Video Input Channel by:
• pressing a button on the remote (see table below)			MENU		CLEAR
• selecting the channel from the TV’s menu system			1	2	3
(see table below)			4	5	6
• tuning directly to the channel by selecting a specific			INPUT Button
			7	8	9
channel number (see table below)			INPUT	0	ANTENNA
• going through all the channels in the channel list by
			REVERSE	PLAY	FORWARD
pressing the channel up or down buttons on the TV.
Some common scenarios are listed in the Video Input Channel			RECORD STOP		PAUSE
Variations table that follows:			- TRACKING + EDIT FR.ADV
Video Input Channel Variations
Button/Switch	Button on the	Channel
on the TV	TV Remote	Number
VIDEO	VID 1	00
SIGNAL	LINE	90
VID 1	VID	91
VID 2	VIDEO	92
S-VID	S-VID	93
S-VIDEO	INPUT	VID 1
	S-VIDEO	VID 2
	SOURCE
	AUX

77