Using the Remote Control
Using the INPUT Button
Use the INPUT button to toggle through the available Video Line Input sources (L1, L2, and regular broadcasting signals) and regular broadcast signals. Video Line Input allows you to view the image from a connected device (like a camcorder) through the VCR.
1.Press the remote control’s VCR button to activate
2.Press the remote control’s INPUT button to tune to the Video Line Input source. L1 represents the rear A/V jacks and L2 represents the front A/V jacks.
3.Press the INPUT button again to tune back to the broadcast signal you were previously watching through the VCR.
Operating a TV with the VCR’s Remote Control
The remote control that came with your VCR can be programmed to operate most brands of
Do You Need to Program the Remote?
To determine whether the remote control needs to be programmed to operate your TV, turn the TV on, point the remote control at it, then press the remote control’s TV button (this puts the remote control into
Programming the Remote Control
To program your remote control, you must use the code list on the next page. Look up the brand name of your TV and the code(s) that brand uses.
Notes: This remote control may not operate all models of the brands shown in the code list.
Note the difference between the TV and VCR
1.Turn on the TV.
2.Find your TV brand and code number(s) in the code list.
3.Press and hold the TV button on the remote control.
4.Enter the code from the code list.
5.Release the TV button, then press the CHAN up or down button. If the TV responds to the remote control’s command, the remote is programmed.
6.If the TV does not respond, repeat these steps using the next code listed for your TV’s brand.
28 | Chapter 3 |
