6. Set up (EX-BC only)

EX-BC

SE1

(1)

(2)

(3)

EX-BC

SE2

INSTALLING DEBRIS GUARD

Put the debris guard on the gear box, attach it with the 4 screws and hardware provided. (SE1)

(1)debris guard

(2)plate

(3)screw

INSTALLING CUTTING HEAD (SE2)

1.While locking the gear shaft, by inserting the supplied tool into the upper holder on the gear box, loosen and remove the hexagon nut(left- handed)

2.Then screw in the cutting head to the gear shaft over the holders. Hand-tighten it securely.

EX-BC SE3

BALANCE UNIT

1.Put on strap and attach unit to strap.

2.Slide clamp up or down until unit balances with head just touching on the ground. (SE3)

15

Page 15
Image 15
RedMax EXZ2500S-BC EX-BC SE1 SE2 Installing Debris Guard, Debris guard Plate Screw, Installing Cutting Head SE2,  15 