7. Identify the Left Base Cover (88) and the Right | 7 |
|
|
Base Cover (91). Slide the Left Base Cover onto |
|
| |
the Left Upright (84). Slide the Right Base Cover |
|
|
|
onto the Right Upright (85). |
| 84 |
|
|
|
| |
| 88 |
| 85 |
|
|
| |
|
|
| 91 |
8. Remove the Resistance Knob (114) from a re- | 8 |
|
|
sistance mechanism. Make sure that the 3/8" x |
|
| |
4 3/4" Bolt (120) stays inside the resistance |
|
| 85 |
mechanism and that the resistance mecha- |
| 84 | |
nism does not come apart. Note: See the | 114 |
| |
lower drawing to reassemble the resistance | Large | ||
mechanism if necessary. |
| Holes | |
Apply a small amount of the included grease | 115 | 116 | Resistance |
around the Resistance Cone (116) and around |
| Mechanism | |
the Upright Insert (115) in the Left Upright (84). |
|
| 120 |
Insert the Resistance Cone (116) into the |
|
|
|
Upright Insert (115), with the two large holes on |
|
|
|
top as shown. Then, tighten the Resistance |
|
|
|
Knob (114) onto the 3/8" x 4 3/4" Bolt (120). Do |
|
|
|
not fully tighten the Resistance Knob. |
|
| Large |
Attach the other resistance mechanism to | 114 |
| |
the Right Upright (85) as described above. |
| Holes | |
|
|
| 120 |
| 10 |
|
|
