8.Slide the Left Base Leg Cover (82) over the end of the Left Upright (111). Attach the Left Base Leg Cover with three #8 x 3/4" Screws (6) and two #8 x 2 1/4" Screws (7). Be careful not to over- tighten the Screws.
With the help of a second person, carefully tip the treadmill down so that the Base (85) is flat on the floor.
9. With the help of a second person, hold the con- |
sole assembly near the Left Upright (111) and the |
Right Upright (113). |
Connect the Upright Wire Harness (73) to the |
Console Wire (119). See the inset drawing. |
The connectors should slide together easily |
and snap into place. If the connectors do not |
slide together easily and snap into place, turn |
one connector and try again. IF THE CONNEC- |
TORS ARE NOT CONNECTED PROPERLY, |
8 |
82 |
111 |
85 |
6 |
7 |
9 |
Console |
Assembly |
THE CONSOLE MAY BE DAMAGED WHEN |
111
Front of Bracket
YOU TURN ON THE POWER. Insert the con- |
nectors and excess wire into the Right Upright |
(113). |
Insert the front ends of the brackets on the con- |
sole assembly into the Right Upright (113) and |
the Left Upright (111). Then, insert the rest of the |
brackets into the Uprights. Make sure that the |
Wire Harnesses (73, 119) are not pinched. |
| 119 |
| 73 |
119 | 113 |
| |
73 |
|
9
