Reebok Fitness RBTL79607.0 manual Assembly, Make sure that the power cord is unplugged

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor- mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included hex key and your own Phillips screwdriver , rubber

mallet , and adjustable wrench .

Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of the manual. The number after the parentheses shows the quantity needed for assembly. Note: If a part is not in the parts bag, check to see if it is preat- tached to one of the parts to be assembled. Extra hardware may be included. To avoid damaging plastic parts, do not use power tools for assembly.

	#8 x 2 1/4" Screw (7)–4		#8 x 3/4" Screw (6)–6		#8 x 1" Tek Screw
3/8" Star					(1)–4
Washer (8)–8
		Extension Leg		5/16" x 2" Bolt (2)–4
	3/8" Nut (11)–2	Nut (10)–4
5/16" Star
Washer (9)–4
3/8" x 2 3/4" Bolt (5)–2		3/8" x 1" Bolt (4)–7		3/8" x 1 3/4" Bolt (3)–1

1. Make sure that the power cord is unplugged.	1
With the help of a second person, carefully tip	85
the treadmill onto its left side as shown. Partially		81
fold the Frame (55) so that the treadmill is more
stable. Do not fully fold the Frame until the
treadmill is completely assembled.
Attach two Base Pads (81) to the Base (85) with		1
two #8 x 1" Tek Screws (1).
	81	1
	55
	6