Regency FireGenie operating instructions Manual Mode, Auto Mode

MANUAL MODE

Note: Ensure the Remote Control has been turned ON in order to operate in this mode.

Manual mode can be selected by pressing and releasing the AUTO/MAN button until the symbol “MANUAL” is shown on the LCD.

In Manual mode, the Flame can be turned on and off using the Remote Control via the ON/OFF button.

AUTO MODE

There is a 3-minute delay built into the Remote Control. This delay will affect the “AUTO” and “PROG” modes only. Which means the unit may not respond to specific instructions instantly when in either of these 2 modes.

Note: Ensure the Remote Control has been turned “ON” in order to operate in this mode.

In Auto Mode the Remote Control operates as a thermostat to turn the fire on and off depending on what temperature setting it has been programmed to.

Auto mode can be selected by pressing and releasing the AUTO/MAN button until the symbol “AUTO” is shown on the LCD.

In Auto mode, when either the “+” or “-” button is pressed, the Set Temperature will be displayed on the LCD instead of the Room Temperature. The Set Temperature will remain displayed on the LCD for 5 seconds after the button is released and then the display will revert to show the Room Temperature. The Set Temperature can be adjusted while it is displayed using the “+” and “-” buttons.

The LCD will show the following when either the “+” or “-” button is pressed:

Room

Temperature

Set

Temperature

Auto Mode normal	When “+” or “-”
display	button is pressed

8 FPI FireGenieTM Remote Control Manual