INSTALLATION
FLOOR PROTECTION
Please check to ensure that your floor protection and hearth will meet the standards for clearance to combustibles. Your hearth extension must be made from a
FIREBRICK ASSEMBLY
Firebrick is included to extend the life of your insert and radiate heat more evenly. Check to see that all firebricks are in their correct posi- tions and have not become misaligned during shipping.
BRICK FLUE BAFFLE & SECONDARY AIR TUBE INSTALLATION
The flue baffle system located in the upper area of the firebox is removable to make cleaning your chimney system easier. The brick baffles must be installed prior to your first fire. Smoke spillage and draft problems may occur if the baffles are improperly positioned. Check the position of the brick baffles on a regular basis as they can be dislodged if too much fuel is forced into the firebox.
The Large Insert I3100L is shipped with one of the secondary air tubes loose inside the firebox. It needs to be installed after the brick baffle are installed. Follow the directions below.
Large Insert I3100L
3)Important: push both baffle bricks so they are tight against the side walls.
Large Insert (I3100L)
Hearth Heater (H2100M)
The unit arrives with the third air tube (from the front) and the 2 baffle bricks on the floor of the firebox. The baffle bricks are positioned first and then the air tubes are installed.
1)Slide the left baffle brick over the two rear air tubes and then push it all the way to the left side of the firebox.
Front View
4)Install the third air tube into the holes on the side channels. The notch goes on the right hand side with the air holes facing forward toward the door opening. If the tube will not slide in easily, simply use a pair of vise grips or pliers and tap it into place with a hammer. A tighter fit will ensure the tube will not move when the unit is burning.
DOOR HANDLE
Attach spring handle by rotating counter clock- wise onto rod. Ensure that the rod fits into the entire length of the spring handle.
2)Tilt the first Baffle Brick down and then slide the 2nd Baffle Brick up and back. Reposition both baffle bricks flat on the air tubes.
Note: When cleaning the chimney reverse the above procedures, removing the air tube and baffle bricks and then replace them when cleaning is completed.
Regency Wood Insert & Hearth Heater | 11 |
