INSTALLATION
FULL SCREEN DOORS
1)Hold the full screen faceplate up against the unit in order to make the following wire connections.
Pull the ON/OFF connector wires thru the box and connect them to the switch.
Connect the fan switch wires with the wire connectors from the fan speed control. Place clips over wires and tuck into side trim.
3)Completely secure faceplate to the unit by securing 4 screws to the Left and Right Side Trim.
4) Secure the Top Frame by sliding it on the screws at the top of the full screen door. It is held in place by magnets.
2)Lift the unit up slightly and push down on the corners of the Bottom Trim Bracket and slide under unit.
Screw
Push in Corners | Top Frame |
Bottom Trim 
Bracket
16 | U35 FPI Direct Vent Gas Insert |
