Regency U35-LP1 Optional Bay Door, Optional Bay Trim, Double Screen Doors, Bay Louvers, Diagram

Models: U35-NG1 U35-LP1

1 32
Download 32 pages 26.72 Kb
Page 13
Image 13
OPTIONAL BAY DOOR

INSTALLATION

OPTIONAL BAY DOOR

The Bay louvers MUST be used

with the Bay glass option.

The optional Bay door is an overlay on the flush front. The standard flush door and glass must remain on the unit. Hook the top of the bay door over the flush door flange and swing the bottom against the bottom flange of the flush door. Press down on the Bay Bottom bracket and push in until it clips behind the bottom of the flush front.

OPTIONAL BAY TRIM

Attach 4 supplied magnets each to the back of the top and bottom trim pieces, and attach trim to the top and bottom of Bay door. See diagrams 3 and 4.

Diagram 3

3)Slide the valve extension knobs onto the valve knobs. Match each extension knob with the corresponding valve knob. Extension knobs are for Bay Front installations only.

DOUBLE SCREEN

DOORS

1) Pull out the top louver.

2) Center the screen door and hook over the flush door.

Diagram 4

BAY LOUVERS

Removing Bay Door

To remove only theBay Door- use a screwdriver to unclip the Bay Bottom bracket from the flush door and then swing up and unhook from the top flush door flange.

To remove the Bay Door & the Flush Front together, pull the hook from the slot in the bottom door bracket under the unit (see Standard Flush Door instructions above). Then pull the Bay Door and Flush door out and lift off of the flange at the top of the unit.

Note: If any maintenance etc. must be done in the firebox, first remove the Bay louvers and door.

1)Install top louver by sliding the two bracket clips into the brackets located on top of the bay door. See below.The fitted louver leaves a small gap between faceplate bottom and louver top.

2)Install bottom louver by sliding the two bracket clips into the brackets located underneath the bay door. Secure with 1 screw into each Bottom Louver Mounting Bracket as per diagram below. Use the bottom hole in the bracket.

3)Open the screen door(s) and secure the screen door to the flush door front with 2 clips on the bottom left and right side.

Clip locations

Clip installed on right side.

U35 FPI Direct Vent Gas Insert

13

 

Page 13
Image 13
Regency U35-LP1 Optional Bay Door, Optional Bay Trim, Double Screen Doors, Bay Louvers, The Bay louvers MUSTbe used