MAINTENANCE
If your valve requires maintenance or replace- ment, follow these instructions:
NOTE: Always shut off the gas supply before removing the valve.
1)Open front pedestal door and unhook chain. You may want to put a soft cloth on the base of the unit so that when the pedestal door is open it doesn't scratch the paint. See diagram below.
REMOVING VALVE
4) Remove the two outside frame pieces by 9) Carefully lift the burner tray assembly out. removing two screws per side. See diagram
below.
5) Carefully remove the logs and lava rock.
6)At this point you should disconnect the gas at the valve.
7)Remove the burner by removing the two 1/4" hex head screws. See diagram be- low.
10)To replace the burner tray assembly, simply reverse these instructions.
2)Undo the six screws holding the control panel in place.
3)Disconnect all wires from the back of the panel and then remove panel. You should lay the panel on a soft cloth so it doesn't get marked up. See diagram below.
Note: Use a magnetic type screwdriver.
8)Remove eight 1/4" hex head screws holding the burner tray assembly in place.
Regency | 19 |
