INSTALLATION
STOVE ASSEMBLY
PRIOR TO
INSTALLATION
Rear Heat Deflector | Pedestal Assembly |
Assembly for F2400M | F2400M & S2400M |
|
All units require either the pedestal or 4 legs at- | The rear heat deflector is supplied with the stove | |
and must be installed unless the optional airmate | ||
tached to the base. The F2400M stove requires | ||
hasbeenselected.Itstopstheheatradiatedfrom | ||
either the Airmate or Rear Heat Defl ector on top | ||
the flue collar from overheating the rear wall.The | ||
ofthestove.Clearancestocombustiblematerials | ||
rear heat defl ector is installed on top of the rear | ||
vary depending on whether the airmate or rear | ||
heat defl ector is installed, so be sure to check heat shield, as shown in Diagram 4. | ||
the Minimum Clearances, Installation section. |
|
Airmate Assembly for F2400M
(850-105)
1)The airmate sits on top of the stove with
the slots in the sides fi tting over the curved defl ector on the rear stove top. See diagram 1. Discard the Rear Heat Defl ector that is supplied with the unit, it is not required if the airmate is installed.
2) Center the airmate and push it forward to the front of the stove. The back of the airmate should be level with the back and sides of the rear heat shield. See Diagrams 2 & 3.
Diagram 4
S2400M Side Shield Adjustment
The left and right side shields are lowered for shipping and handling. It allows for a handhold on the top of the stove. Before placing in the Step Stove in its fi nal position, the side shields must be raised.
Loosenthescrewsontherearonthestove(3per side), slide the side panel up as far as possible and then secure by tightening the screws.
Diagram 1
Diagram 2
Diagram 3
1)For easier assembly, tip the stove on its back (onto a soft surface to prevent scratch- ing).
Hint: If you have chosen the Ash Drawer option, remove the ash dump cover plates before attaching the pedestal. See page 17 "Ashdrawer Kit Installation".
2)Remove the blanking plate if
a)youarenotinstallingoutsidecombustion air or
b)outside air is to be brought in from the rear of the stove.
3)Unscrew the 4 bolts in the
4)Push the
Regency logo into the two holes in the front bottom left corner of the pedestal cover plate.
Note: Any paint touch up should be done prior to placing logo on pedestal.
5)If not using ash drawer, then cover plate must beinstalled.Ifusingashdrawer,thendisregard cover plate.
10 | Regency Freestanding Woodstove |