Promise Technology 66 Pro SuperCheck Installation, Installation Scenarios, All Scenarios

Models: 66 Pro

1 159
Download 159 pages 54 Kb
Page 45
Image 45

SuperTrak66™ User's Manual

Chapter 4

4.1 SuperCheck Installation

SuperCheck has many component modules, which, depending on your scenario, may or may not need to be installed on your system. The following “Installation Scenarios” describe what components are to be installed, and where.

Installation Scenarios

The following installation scenarios each detail a separate software installation model. Some scenarios are based on a single system, while others involve multiple systems on a LAN or WAN. Select the scenario(s) which best match your needs, then follow the installation steps listed for that scenario. Each of these components may be installed by following the “Common Components” installation procedure outlined on p.36. Proceed to section 4.2 once installation is complete to begin “SuperCheck Administration.”

NOTE: All systems with the SuperTrak66 controller will require the Message Agent software (includes automatic installation of the I2O device driver). Additionally, the component installations that follow require TCP/IP to be already properly installed on the server system. Chapter 2 contains some information about installing TCP/IP on Windows NT.

NOTE: While you may install multiple systems with the Message Server software, Promise recommends against it because the same SuperTrak arrays will be visible from every instance of the Promise Message Server, causing confusion.

All Scenarios:

1)If the system is on a LAN or WAN, use the IP address for which your TCP/IP is already configured to establish connections. Otherwise, use IP address 127.0.0.1 for all your TCP/IP configurations; This address will allow all TCP/IP requests to remain within the system.

2)Install the Message Agent on the station with SuperTrak66 (automatically installs I2O driver component).

3)Reboot the system AFTER all software components have been installed in order to activate any installed NT services.

To access a SuperTrak system locally

1)Install the Message Server on to this system.

2)Install the Monitoring Utility onto this system.

- 34 -

Page 45
Image 45
Promise Technology 66 Pro user manual SuperCheck Installation, Installation Scenarios, All Scenarios