INSTALLATION
BRICK INSTALLATION
Firebrick is included to extend the life of your stove and radiate heat more evenly. Check to see that all fi rebricks are in their correct posi- tions and have not become misaligned during shipping.
The "AD" brick in the drawings below is the brick covering the Ash Dump hole that is used when the Ash Drawer Kit is installed.
STEP-BY-STEP
OPTIONAL
ACCESSORIES
INSTALLATION
The pieces listed below can be purchased and installed during the initial installation or added on later.
4)Push the ash plug into the hole inside the fi rebox and replace all the bricks except for the brick over the ash plug (see brick diagram in the Brick Installation section).
5)Place the ash plug tool beside the lid, then slide the ash drawer inside.
Refer to Ash Drawer Operating Guidelines in the Operating Instructions section.
DOOR HANDLE
Attach spring handle by rotating counter clock- wise onto rod. Ensure that the rod fi ts into the entire length of the spring handle (refer to the Diagram below).
Pedestal Ash Drawer Kit (850-100)
1) Remove the bricks from the fl oor of the
firebox.
2)If using ashdrawer, discard cover plate.
3)Remove the ash dump cover plates (one inside the fi rebox and one on the underside of the fi rebox) by removing the two nuts and boltsholdingthe2platestogetherfrominside the fi rebox.
4)Push the ash plug into the hole inside the
firebox and replace all the bricks except for the brick over the ash plug (refer to the brick diagram in the Brick Installation section).
5)Place the ash drawer lid inside the pedestal, and the ash plug tool beside the lid, then slide the ash drawer inside so it sits on top of the lid.
SCREEN DOOR
Hook screen to the inside on the right side of the fi rebox door opening. Lock in place by turning handle.
GLASS INSTALLATION
Remove the door from the stove and remove the glass retainer. Position the glass in the door, make sure that the glass gasketing will properly seal your unit, and replace the retainer, it should restonthegasketnottheglass.Tightensecurely, but do not wrench down on the glass as this may cause the glass to break.
Refer to the Ash Drawer Operating Guidelines in the Operating Instructions section.
Bottom Shield Ash Drawer Kit
1) Remove the bricks from the fl oor of the
fi rebox.
2)Remove and discard the cover plate by removing the two screws on the front of the Bottom Shield.
3)Remove the ash dump cover plates (one inside the fi rebox and one on the underside of the fi rebox) by removing the two nuts and boltsholdingthe2platestogetherfrominside the fi rebox.
Hooks | Handle Lock |
Back Side of Screen Shown
NOTE: The handle must be positioned at 10 o'clock when closed to avoid the handle from getting hot and to ensure the screen stays in place.
Handle at 10 o'clock position.
Regency Freestanding Woodstove | 17 |
