INSTALLATION
shut off the supply of gas within 5 - 10 minutes. Tampering with the switch can result in carbon monoxide (CO) poisoning and possible death.
If the heater turns off because of lack ofdraftduringthespillagetest,check for the cause and if necessary, seek expert advice.
The thermally actuated safety switch will automatically reset after it has reduced in temperature. The switch will continue to cycle until the draft problem is corrected. DO NOT BYPASS OR DISCONNECT THIS SWITCH.
3) Using the trim clips provided, join the left side gold trim (the one with the ON/OFF switch and variable speed FAN switch) to the top gold trim. See diagram 2. Repeat this step for right side.
tighten top screw only
Trim Clips
Rear View
Diagram 2
Diagram 4
FACEPLATE AND TRIM
INSTALLATION
Hint: Before doing the faceplate installation, leave the Insert out approximately 4" so wires may be hooked up more easily.
1)Lay the faceplate panels fl at, face down on something soft so they don't scratch.
2)Take the top faceplate and align the holes in it with the holes in the side panels. Attach, using the screws provided. See diagram 1.
4) | Place the trim on the assembled faceplate |
| panels, aligning the wires from the switches |
| with the notch in the left side faceplate |
| panel. |
| The power cord should be run behind the |
| faceplate panel. |
5) | Push the Regency logo plate into the two |
| holes in the bottom left corner of the face- |
| plate. |
6) | Secure the brass trim to the faceplate by |
| drilling a 1/8" hole through into the faceplate |
| side fl ange, using the hole in the brass trim |
| as a guide. Now fasten with the two brass |
| plated screws provided. |
7) | Lift the assembled faceplate up and over the |
8)Fan Switch wires: Connect the plug end from the fan switches to the matching plug from the unit. See Diagram 5. Make sure the plugs are pushed together as far as they can go. Push the connection into the hole in the side of the insert so it is locked into place.
9)ON/OFF wires: Hook up the ON/OFF wires to the switch on the left side trim. Diagram 5.
Screws
Right
Side
Tabs
Top
Hinged Louvers
top of the insert and then lower it down so the |
faceplate tabs are in line with the faceplate |
brackets. See diagram 3. Once everything |
is properly lined up you can tighten the 4 |
screws on the faceplate brackets. See |
diagram 4. |
Diagram 5
Diagram 1
Note: The holes in the top panel are slightly larger than the holes in the side panel to facilitate easier installation.
Hint: Don't tighten the screws down completely at this point, fi rst do a trial fi t to the unit. Make any necessary adjustments and when it fi ts properly then tighten down the screws.
Diagram 3
Note: If you are making custom
Regency | 11 |
