Remington 491 operating instructions Power Loads and Fasteners

Safety Precautions

30

WATER

2.Should the tool fail to fire, hold the muzzle firmly against the work surface for 30 seconds. Release the trigger and remove pressure on the tool while holding the muzzle against the work surface. Again press the tool firmly against the work surface and pull the trigger. If the tool still fails to fire, hold the tool firmly against the work surface for another 30 seconds before advancing the power load strip. Use remaining loads in strip. Discard power load strip into water or oil.

Spall

Sheild

3.Always use the spall shield when driving directly into concrete or steel. Always wear approved goggles.

GASOLINE

OLINE

482-50

482-49

4.Never use a powder actuated tool in an explosive or flammable atmosphere or when non-sparking tools are required.

POWER LOADS AND FASTENERS

1.Never leave unfired power load strips on floors or work surfaces.

099494 9