HP 6330US Accessibility, Voltage Select Switch, Internal Battery, Power Cords, Extension Cord

7IMPORTANT ELECTRICAL AND MECHANICAL SAFETY INFORMATION

Accessibility

Be sure that the power outlet you plug the power cord into is easily accessible and located as close to the equipment operator as possible.When you need to disconnect power to the equipment, be sure to unplug the power cord from the electrical outlet.

Voltage Select Switch

Ensure that the voltage select switch is in the correct position for the type of voltage you use (115VAC or 230VAC).

Internal Battery

Your computer may contain an internal battery-powered real-time clock circuit. Do not attempt to recharge the battery, disassemble it, immerse it in water, or dispose of it in fire. Replacement should be done by a Compaq authorized service provider using the Compaq spare part for the computer.

Power Cords

If you have not been provided with a power cord for your computer or for any AC-powered option intended for use with your computer, you should purchase a power cord that is approved for use in your country.

The power cord must be rated for the product and for the voltage and current marked on the product’s electrical ratings label.The voltage and current rating of the cord should be greater than the voltage and current rating marked on the product. In addition, the diameter of the wire must be a minimum of 0.75 mm2/18AWG and the cord should be between 5 and 6.5 feet (1.5 and 2 meters) long. If you have questions about the type of power cord to use,contact your Compaq authorized service provider. Route the power cord so that it will not be

walked on,tripped over,or pinched by items placed upon or against it. Pay particular attention to the plug, electrical outlet, and the point where the cord exits the product.

Protective Attachment Plug

In some countries, the product cord set may be equipped with a wall plug having overload protection.This is a safety feature. If the plug needs to be replaced, be sure the Compaq authorized service provider uses a replacement plug specified by the manufacturer as having the same overload protection as the original plug.

Extension Cord

If an extension cord or power strip is used, make sure that the cord or strip is rated for the product and that the total ampere ratings of all products plugged into the extension cord or power strip do not exceed 80% of the extension cord or strip ampere ratings limit.

36