IMPORTANT SAFETY INFORMATION
WARNING: When using an electric chain saw, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:
READ ALL INSTRUCTIONS.
Make sure you read and understand all instructions in Important Safety Informa- tion on pages 2 through 4. Improper use of this chain saw can cause severe injury or death from Þre, electrical shock, body contactwithmovingchain,orfallingwood.
BEFORE OPERATING SAW
1.Read and understand this ownerÕs manual be- fore operating chain saw.
2.Watch what you are doing. Use common sense. Do not operate saw when you are tired.
3.Use chain saw for cutting wood only. Do not use chain saw for purpose not intended. Do not use for cutting plastic, masonry, etc.
4.Only
5.Use only electrical voltage noted on model plate of chain saw.
6.Use only extension cords marked for outdoor use. See page 17 for extension cord requirements.
7.Do not operate chain saw
¥while under the inßuence of alcohol, medica- tion, or drugs
¥in rain or in damp or wet areas
¥where highly ßammable liquids or gases are present
¥if saw is damaged, adjusted wrong, or not fully and securely assembled
¥if trigger does not turn saw on and off. Chain must stop moving when you release trigger. Have faulty switch replaced by authorized ser- vice center (see Technical Service, page 21).
¥while in a hurry
¥while in tree or on a ladder unless trained to do so
8.Wear
9.Wear the following safety gear when operating chain saw.
¥
¥
¥eye protection such as safety glasses, goggles, or face screen
¥safety hard hat
¥ear mufßers or ear plugs
¥hair covering to contain long hair
¥face or dust mask (if working in dusty areas)
10.Before cutting, always provide the following:
¥clear work area
¥secure footing
¥planned retreat path from falling tree
11.Inspect tree before cutting down. Make sure there are no dead limbs or branches that may fall on you.
12.To reduce the risk of electric shock, this saw has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the out- let of your extension cord, reverse the plug. If it still does not fit, a polarized extension cord will be necessary. Do not change the plug in any way.
WHILE OPERATING SAW
1.Stay alert. Use common sense while operating chain saw.
2.Keep work area clean. Cluttered areas invite in- juries.
3.Be aware of extension cord while operating chain saw. Be careful not to trip over cord. Keep cord away from chain and operator at all times.
4.Keep children, animals, and bystanders away from chain saw and extension cord. Only chain saw user should be in work area.
5.Do not cut down a tree unless you are trained or have expert help.
6.If two or more persons perform bucking and fell- ing operations at the same time, provide plenty of distance between operations. Provide distance of at least twice the height of tree being felled.
7.Secure wood you are cutting by using clamps or chocks.
8.Grip chain saw Þrmly with both hands. Never operate chain saw with one hand. Never use hand guard as handle.
9.Keep Þnger off trigger until ready to make cut.
10.Before starting chain saw, make sure chain is not touching anything.
11.To guard against electrical shock, avoid body contact with grounded objects such as pipes, fences, and metal posts.
12.Keep all parts of body away from chain when saw is running.
13.Do not force chain saw while cutting. Apply light pressure. It will do the job better and safer at the rate for which it was intended.
14.Cut small brush and saplings with extreme care. Slender material may catch in chain and be whipped toward you. This could also pull you off balance.
15.When cutting limb or tree trunk that is under ten- sion, use extreme caution. Be alert for wood springing back. When wood tension is released,
www.desatech.com | 2 | 108539 |
|
|
