CLEANING AND
MAINTENANCE
Continued
4.Hold Þle guide level. Make sure 30° mark on Þle guide is parallel to center of guide bar (see
Figure 19). This will insure that you Þle cutters at 30° angle.
5.File from inside towards outside of cutter until sharp. Only Þle in this one direction (see Figure 19). Note: Two or three strokes with Þle should sharpen cutter.
6.After each cutter is sharpened, move chain for- ward to sharpen next cutter. File all cutters on one side of chain.
7.Move to other side of chain and repeat process.
Filing Cutter Depth Gauges
The cutter depth gauge clearance is reduced as cut- ters are sharpened. After every second or third sharp- ening, reset cutter depth gauges.
1.Place depth gauge tool (.025") Þrmly across top of two cutters. Make sure depth gauge enters slot in depth gauge tool (see Figure 21).
2.Use medium ßat Þle. File depth gauge level with depth gauge tool.
3.Remove depth gauge tool. With ßat Þle, round off front corner of cutter depth gauge (see Fig- ure 22).
After several hand Þlings, have authorized service center or sharpening service machine sharpen chain. This will insure even Þling.
REPLACING SAW CHAIN
Replace chain when cutters are too worn to sharpen or when chain breaks. Only use replacement chain noted in this manual.Always include new drive sprocket when replacing chain. This will maintain proper driving of chain. Note: For proper chain and drive sprocket, see Replacement Parts and Accessories.
STORAGE
If storing saw for more than 30 days, follow steps below.
1.Drain oil tank.
2.Remove and clean guide bar and chain. Clean guide bar and chain by soaking in petroleum based solvent or mild soap and water mixture.
3.Dry guide bar and chain.
4.Place chain in container Þlled with oil. This will prevent rust.
5.Wipe a thin coating of oil over surface of guide bar.
6.Wipe off outside of saw body. Do this with soft cloth dampened with a mild soap and water mixture.
7.Store chain saw
¥in a high or locked place, out of childrenÕs reach
¥in a dry place
¥in a carrying case or with scabbard over guide bar
TECHNICAL SERVICE
You may have further questions about assembling, operating, or maintaining this saw. If so, contact DESA InternationalÕs Technical Service Department at
You can also visit DESA InternationalÕs technical service web site at www.desatech.com.
SERVICE PUBLICATIONS
You can receive an illustrated parts list free of charge. Send a
When writing, include model number and serial num- ber of saw. You will Þnd these numbers on saw mo- tor housing decal.
REPLACEMENT PARTS AND ACCESSORIES
DESA International P.O. Box 90004
Bowling Green, KY
Parts Department
WARNING: Use only replacement parts and accessories described in this manual. Use of other parts or accessories could damage saw or injure operator.
For a list of Authorized Service Centers or Parts Dis- tributors near you, call
You may purchase the following service or replace- ment parts:
|
|
Part Number | Description |
Guide bar, 8" (20.3 cm) | |
104301S# | Chain, 8" (20.3 cm) |
Guide bar, 10" (25.4 cm) | |
091371S | Chain, 10" (25.4 cm) |
Guide bar, 12" (30.5 cm) | |
Chain, 12" (30.5 cm) | |
075752 | Drive Sprocket |
099178H, | |
Part Number | Description |
Guide bar, 14" (35.5 cm) | |
Chain, 14" (35.5 cm) | |
075752 | Drive Sprocket |
#Must order both pieces
Continued
108539 | 21 | www.desatech.com |
|
|
