¨
ELECTRIC CHAIN SAW
PRODUCT |
|
|
IDENTIFICATION | Front Hand |
|
|
| |
| Guard | Guide Bar |
|
| |
|
| Nose |
| Saw |
|
| Chain |
|
Rear |
|
|
Handle |
|
|
|
| Guide Bar |
| Sprocket |
|
| Cover |
|
Rear Hand |
|
|
Guard |
|
|
Power Cord |
| Scabbard |
|
|
The plastic hardware bag should include:
•two guide bar bolts
•two guide bar nuts
•one
1.Lay chain out flat.
2.Install front hand guard onto saw body. Do this by pressing two mounting stand- outs on hand guard into
3Insert tapping screw through hand guard and into saw handle. Tighten screw firmly.
4. Turn adjusting screw counterclockwise |
(see Figure 4, page 7). Continue to turn |
adjusting screw until adjusting block is |
to rear of adjusting plate. |
5. Install guide bar onto saw body. Place |
rear of guide bar between adjusting |
plate and sprocket support. |
IMPORTANT: Make sure to insert ad- |
justing block into oval adjusting hole |
on guide bar. |
Front Handle
Spike
Motor Housing
Figure 2 - Electric Chain Saw
Oil Level Sight Hole (located on saw body, hidden by front handle)
Oil Cap With
Squeeze Bulb
Switch Trigger
Lockout
6. | Line up holes on sprocket support with |
| center slot on guide bar and holes in |
| saw body. |
7. Insert guide bar bolts through front | |
| hand guard, saw body, center slot of |
| guide bar, and sprocket support. Attach |
| guide bar nuts to guide bar bolts. |
| IMPORTANT: Tighten guide bar nuts |
| finger tight only. Make sure adjusting block |
| is in oval adjusting hole on guide bar. |
8. | Place chain around drive sprocket, then |
| along top groove of guide bar and |
| around guide bar nose. Note: Make |
| sure cutting edges of chain are facing |
| the right direction. Position chain so |
| cutting edges on top of guide bar face |
| guide bar nose (see Figure 3, page 7). |
CAUTION: Do not place chain
UNPACKING
1.Remove all items from carton.
2.Check all items for any shipping dam- age. If you find any damage or if any parts are missing, promptly inform dealer where you bought chain saw.
ASSEMBLY
Note: Some models are pre assembled. As- sembly is not needed on these models. See Saw Chain Tension Adjustment, page 8.
WARNING: Cutting edges on chain are sharp. Use protective gloves when handling chain.
IMPORTANT: Do not clamp chain saw in vise during assembly.
on saw backwards. If chain is backwards, saw will vibrate badly and will not cut.
9.Adjust saw chain tension. Follow steps under Saw Chain Tension Adjustment, page 8.
For more information, visit www.desatech.com | 6 | 105020 |
