ASSEMBLY
UNFOLDING AND ADJUSTING HANDLEBAR
Unfolding Handlebar
1.Loosen handlebar adjustment knobs. Rotate the handlebar into the operat- ing position (see Figure 1). Do not force handlebar. If there is binding, continue to loosen adjustment knobs. Be careful not to pinch power cord between handlebar and lower handlebar support.
2.Tighten handlebar adjustment knobs.
Adjusting Height of Handlebar
The handlebar has two possible height set- tings. The tiller is shipped with the handlebar mounted in the standard height or lowest position. If this height is too short, adjust the height of the handlebar to the extended height or highest position.
1.Loosen and remove handlebar adjust- ment knobs, washers, and saddle bolts from handlebar.
2.Position handlebar so that the bottom holes in the handlebar line up with the holes in the lower handlebar supports (see Figure 2). Insert the saddle bolts through the holes and reinstall the washers and handlebar knobs.
3.Tighten handlebar adjustment knobs.
Folding Handlebar For Storage
1Loosen handlebar adjustment knobs. Rotate the handlebar forward and down over the tiller housing (see Figure 3). Do not force handlebar. If there is binding, continue to loosen knobs. Be careful not to pinch power cord be- tween handlebar and lower handlebar support.
2Tighten handlebar adjustment knobs.
ENGLISH
Handlebar |
|
| |
|
| Handlebar | |
| Saddle | Standard Height | |
| Bolt | Adjustment Hole | |
|
| Handlebar | |
|
| Adjustment | |
|
| Knob | |
| Handlebar | Lower | |
Handlebar | Adjustment | Handlebar | |
Knob | Support | ||
Adjustment | |||
| Washer | ||
Knob |
| ||
|
| ||
Lower |
|
| |
Handlebar |
|
| |
Support |
| Figure 3 - Folding Handlebar Down | |
| Extended Height | ||
|
| ||
| Adjustment Hole |
| |
Figure 1 - Unfolding Handlebar | Figure 2 - Adjusting Handlebar Height | ||
7 | www.remingtonpowertools.com |
