Remington Power Tools 494 operating instructions Know Your Fastening Base Material

Safety Precautions

?

?

?

G 018

7.An operator taking medication should take extra precautions while handling the tool. NEVER drink alcoholic beverages or take medications which impair your vision, balance or judgement before using a powder actuated tool.

KNOW YOUR FASTENING BASE MATERIAL

? ?

?

?

CENTER

PUNCH TEST

Sinks in with average hammer blow

				482-28
				G 018
482-26	482-27
				Start
Point	Surface
flattens	shatters		1	2
			GRAY	BROWN
	BRITTLE		3	4
482-29		482-30	GREEN	YELLOW
G 018	G 018
				482-31

1.ALWAYS know the thickness and type of base material into which you are fastening. NEVER GUESS. Test the base material by using the Center Punch Test. The Center Punch Test is performed by using a hammer to test drive the particular power fastener to be used into the material. If the point penetrates easily, the material is too soft. If the point becomes blunt, the material is too hard. If the material fractures, cracks or shatters, the material is too brittle. Test fastenings can be made if the material shows a clear fastener impression and the fastener point is not blunted. ALWAYS start with the lowest power load (Gray-Level 1) and proceeding with the order shown in the lower right-hand figure above. Always wear approved goggles.

101437

6