OWNER’S MANUAL
CHAIN SAW NAMES AND TERMS
Boring The process involved in cutting with the saw chain at the nose (tip) of the guide bar, in order to make a hole. This is not recommended because of hazard of kick- back.
Bucking The process of cross cutting a felled tree or log into lengths.
Chain Saw Powerhead A chain saw without the saw chain and guide bar.
Clutch A mechanism for connecting and disconnecting a driven member to and from a rotating source of power.
Drive Sprocket or Sprocket The toothed part that drives the saw chain.
Felling The process of cutting down a tree.
Felling Back Cut The final cut in a tree felling operation made on the opposite side of the tree from the notching undercut.
Front Handle The support handle located at or toward the front of the chain saw.
Front Handle Guard A structural barrier between the front handle of a chain saw and the guide bar, typically located close to the hand position on the front handle.
Guide Bar A solid railed structure that supports and guides the saw chain.
Kickback The backward and/or upward motion of the guide bar occurring when the saw chain near the nose of the top area of the guide bar contacts any object such as an- other log or branch, or when the wood closes in and pinches the saw chain in the cut.
Kickback, Pinch The rapid pushback of the saw which can occur when the wood closes in and pinches the moving saw chain in the cut along the top of the guide bar.
Kickback, Rotational The rapid upward and backward motion of the saw which can occur when the moving saw chain near the upper portion of the tip of the guide bar contacts an object, such as a log or branch.
Normal Cutting Position Those posi- tions assumed in performing the bucking and felling cuts.
Notching Undercut A notch cut in a tree that directs the tree’s fall.
Oiler Control A system for oiling the guide bar and saw chain.
Rear Handle The support handle located at or toward the rear of the saw.
Reduced Kickback Guide Bar A guide bar which has been demonstrated to reduce kickback significantly.
Saw Chain A loop of chain having cutting teeth, that cut the wood, and that is driven by the motor and is supported by the guide bar.
Spiked Bumper (Spike) The pointed tooth or teeth for use when felling or bucking to pivot the saw and maintain position while sawing.
Switch A device that when operated will complete or interrupt an electrical power circuit to the motor of the chain saw.
Switch Linkage The mechanism that trans- mits motion from a trigger to the switch.
Switch Lockout A movable stop that prevents the unintentional operation of the switch until manually actuated.
101755 | 3 |
