Renesas H8S/2615 Series user manual Check the location of pin 1 before inserting

2.2.3Inserting Cable Head

CAUTION

Check the location of pin 1 before inserting.

Align pin 1 on the IC socket for an FP-80Q package on the user system with pin 1 on the user system interface cable head, and insert the user system interface cable head into the IC socket on the user system, as shown in figure 3.

2.2.4Fastening Cable Head

CAUTION

1.Use a Philips-type screwdriver whose head matches the screw head.

2.The tightening torque must be 0.0785 N•m or less.

If the applied torque cannot be accurately measured, stop tightening when the force required to turn the screw becomes significantly greater than that needed when first tightening. If a screw is tightened too much, the screw head may break or an IC socket contact error may be caused by a crack in the IC socket solder.

3.If the emulator does not operate correctly, cracks might have occurred in the solder. Check conduction with

a tester and re-solder the IC socket if necessary.

6