Renesas SH7362 - page 20

Notes: 1. Do not use /RESETP in the emulator after the user system has been activated.

When reset signals are used for debugging, use /RESETA.

2. Fix /RESETA as high level when it is not used.

3. When the voltage level of VccQ_SR (power supply for H-UDI and AUD) is 2.85 V

and that of VccQ_MFI (power supply for /RESETA) is 1.8 V, a level-shift circuit is

required as shown in the figure.

Contents

Main Revision Date: Aug. 20, 2007 Rev.1.00 SuperH Family E10A-USB Emulator Page Notes regarding these materials Page Contents Page Section 1 Connecting the Emulator with the User System 1.1 Components of the Emulator 1.2 Connecting the Emulator with the User System 1.3 Installing the H-UDI Port Connector on the User System 1.4 Pin Assignments of the H-UDI Port Connector 1. Input to or output from the user system. 2. The symbol (/) means that the signal is active-low. Figure 1.2 Pin Assignments of the H-UDI Port Connector (36 Pins) H-UDI port connector (top view) H-UDI port connector (front view) Pin 1 Pin 8 Pin 7 Pin 14 Figure 1.3 Pin Assignments of the H-UDI Port Connector (14 Pins) this pin and the MPMD pin is set to 0, do not connect to GND but to the MPMD pin directly. Figure 1.4 Pin Assignments of the H-UDI Port Connector (38 Pins) 1.5 Recommended Circuit between the H-UDI Port Connector and the MPU Page Page Page Section 2 Software Specifications when Using the SH7362 2.1 Differences between the SH7362 and the Emulator Page Page Page Page 2.2 Specific Functions for the Emulator when Using the SH7362 Table 2.5 Dialog Boxes for Setting Event Conditions Table 2.5 Dialog Boxes for Setting Event Conditions (cont) Table 2.6 Sequential Event Conditions (cont) Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Table 2.11 Conditions Specified in the [Action] Page Page Page Table 2.12 Measurement Items Page Page Page Page Page Page Page Page http://www.renesas.com Page SuperH