Renesas SH7362 - page 46

40

2.2.5 Notes on Setting the [Event Condition] Dialog Box and the BREAKCONDITION_

SET Command

1. When [Go to cursor], [Step In], [Step Over], or [Step Out] is selected, the settings of Event

Condition 3 are disabled.

2. When an Event Condition is satisfied, emulation may stop after two or more instructions have

been executed.

3. If a PC b reak address condition is set to the slot instruction after a delayed branch instruction,

user program execution cannot be terminated before the slot instruction execution; execution

stops before the branch destination instruction.

2.2.6 Note on Setting the UBC_MODE Command

In the [Configuration] dialog box, if [User] is set while the [UBC mode] list box has been set,

Ch10 (IA_OA_R) and Ch11 (OA_OA_CT_R) of Event Condition cannot be used.

2.2.7 Note on Setting the PPC_MODE Command

In the [Configuration] dialog box, if [User] is set while the [PPC mode] list box has been set, Ch1

and Ch2 of the performance analysis function and options 1 and 2 of the profile function cannot be

used.

Contents

Main Revision Date: Aug. 20, 2007 Rev.1.00 SuperH Family E10A-USB Emulator Page Notes regarding these materials Page Contents Page Section 1 Connecting the Emulator with the User System 1.1 Components of the Emulator 1.2 Connecting the Emulator with the User System 1.3 Installing the H-UDI Port Connector on the User System 1.4 Pin Assignments of the H-UDI Port Connector 1. Input to or output from the user system. 2. The symbol (/) means that the signal is active-low. Figure 1.2 Pin Assignments of the H-UDI Port Connector (36 Pins) H-UDI port connector (top view) H-UDI port connector (front view) Pin 1 Pin 8 Pin 7 Pin 14 Figure 1.3 Pin Assignments of the H-UDI Port Connector (14 Pins) this pin and the MPMD pin is set to 0, do not connect to GND but to the MPMD pin directly. Figure 1.4 Pin Assignments of the H-UDI Port Connector (38 Pins) 1.5 Recommended Circuit between the H-UDI Port Connector and the MPU Page Page Page Section 2 Software Specifications when Using the SH7362 2.1 Differences between the SH7362 and the Emulator Page Page Page Page 2.2 Specific Functions for the Emulator when Using the SH7362 Table 2.5 Dialog Boxes for Setting Event Conditions Table 2.5 Dialog Boxes for Setting Event Conditions (cont) Table 2.6 Sequential Event Conditions (cont) Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Table 2.11 Conditions Specified in the [Action] Page Page Page Table 2.12 Measurement Items Page Page Page Page Page Page Page Page http://www.renesas.com Page SuperH