ResMed 248672 Reassembling the H4i cleanable water chamber, Cover and cover seal, Docking station

Cover and cover seal

1 2

1Remove the cover by gently flexing one cover arm away and up from the docking station until the cover detaches completely.

2Peel the cover seal away from the cover.

3Inspect the cover and cover seal weekly for wear and deterioration. Replace any damaged parts. When required, wash the cover and cover seal in warm water, using a mild detergent. Rinse them thoroughly with clean water and allow it to dry away from direct sunlight.

Docking station

Periodically wipe the outside of the docking station (including the connector seal) with a damp cloth.

CAUTION

!Do not use any of the following to clean any part of the H4i as these solutions may cause damage and reduce the life of the product:

•bleach, chlorine-, alcohol- or ammonia-based solutions

•moisturising, antibacterial or glycerine based soaps

•water softening and unapproved descaling agents.

Heater plate

Do not allow water to collect on the heater plate. Wipe it with a clean cloth if necessary.

Reassembling the H4i cleanable water chamber

1 2 3 4

English

1Refit the tub plate seal into its groove on the cleanable water chamber.

2Reinsert the tub plate by slotting its feet into the catches.

3Reassemble the catch by lifting up and over the water chamber and then pushing down to lock into place.

Note: Only the H4i Cleanable Water Chamber can be disassembled/reassembled.

Cleaning and maintenance 7