TROUBLESHOOTING
If there is a problem, try the following suggestions. If the problem cannot be solved, contact your equipment supplier or ResMed. Do not attempt to open the device.
Problem | Possible Cause | Solution |
|
|
|
No display. | Power not connected. | Ensure the appropriate power |
|
| cord is connected to your S8 Elite |
|
| and the power switch (if |
|
| available) is on. |
|
|
|
Insufficient air | Ramp time is in use. | Wait for air pressure to build up |
delivered from |
| or change ramp time. |
S8 Elite. | Air filter is dirty. | Replace air filter. |
| ||
| Air tubing is kinked or | Straighten or replace tubing. |
| punctured. |
|
| Air tubing not connected | Check air tubing. |
| properly. |
|
| Mask and headgear not | Adjust position of mask and |
| positioned correctly. | headgear. |
| Cap(s) missing from access | Replace cap(s). |
| port(s) on mask. |
|
| Pressure required for treatment | See your clinician to adjust the |
| may have changed. | pressure. |
|
|
|
S8 Elite does not start | Power cord not connected | Connect power cord firmly at |
when you breathe into | properly. | both ends. |
the mask. |
|
|
ENGLISH
Power outlet may be faulty.
SmartStart not on.
Leak Alert has been enabled; SmartStart has automatically been disabled.
Use of a Mirage or Ultra Mirage Full Face Mask.
Breath is not deep enough to trigger SmartStart.
Try another power outlet.
Enable SmartStart.
Disable Leak Alert to enable SmartStart.
SmartStart does not work with a full face mask as the anti- asphyxia valve will not allow sufficiently high pressure on exhalation.
Take a deep breath in and out through the mask.
TROUBLESHOOTING 33
