(S3PT-8)
(S3PT-2)
(S3PT-1)

 

SAFETY

 

 

 

 

DANGER!

Replace bent or broken blade with new blades. NEVER ATTEMPT TO STRAIGHTEN BLADES

 

SINCE THIS WILL LIKELY CRACK OR OTHERWISE DAMAGE THE BLADE WITH

 

SUBSEQUENT FAILURE AND POSSIBLE SERIOUS INJURY FROM THROWN BLADES.

 

(SGM-10)

SAFETY

WARNING!

DANGER!

WARNING!

WARNING!

WARNING!

Do not mow with two machines in the same area except with Cab tractors with the windows closed.

(SGM-11)

Always disconnect the main PTO Driveline from the Tractor before performing service on the Mower. Never work on the Mower with the tractor PTO driveline connected and running. Blades or Drivelines could turn without warning and cause immediate entanglement, injury or death. (SRM-3)

Do not let the Blades turn when the Mower Deck is raised for any reason, including clearance or for turning. Raising the Mower deck exposes the Cutting Blades which creates a potentially serious hazard and could cause serious injury or even death from objects thrown from the Blades. (SRM-7)

Never leave Tractor and Implemented unattended while the implement is in the lifted position. Accidental operation of lifting lever or a hydraulic failure may cause sudden drop of unit with injury or death by crushing. To properly park the implement when disconnecting it from the tractor, lower the stand and put the retaining pin securely in place, or put a secure support under the A- Frame. Lower the implement carefully to the ground. Do not put hands or feet under lifted components.

Be particularly careful when transporting the Implement with the Tractor. Turn curves or go up hills only at a low speed and using a gradual steering angle. Rear mounted implements move the center of gravity to the rear and remove weight from the front wheels. Make certain, by adding front ballast, that at least 20% of the tractor’s weight is on the front wheels to prevent rearing up, loss of steering control or Tractor tip-over. Slow down on rough or uneven surfaces to prevent loss of steering control which could result in property damage or possible injury. Do not transport unless 3-Point lift lever is fully raised and in the latched transport position. Dropping implement in transport can cause serious damage to the tractor and/or Implement and possibly cause the operator or others to be injured or killed.

DANGER!

WARNING!

Make sure the PTO shield is installed when using PTO-driven equipment. Always replace the PTO shield if it is damaged or missing.

Relieve hydraulic pressure prior to doing any maintenance or repair work on the Implement. Place the Implement on the ground or securely blocked up, disengage the PTO, and turn off the tractor engine. Push and pull the Remote Cylinder lever in and out several times prior to starting any maintenance or repair work. (S3PT-9)

WARNING!

The rotating parts of this machine continue to rotate even after the PTO has been turned off. The

 

operator should remain in his seat for 60 seconds after the brake has been set, the PTO

 

disengaged, the tractor turned off, and all evidence of rotation has ceased. (S3PT-10)

 

“Wait a minute...Save a life!”

GK6072 08/01

Safety Section 1-8

© 2004 Alamo Group Inc.

Page 14
Image 14
Rhino Mounts GK6072 manual Wait a minute...Save a life