3Face the A mark on the battery up, and insert it into
the battery charger.
Insert the battery into the battery 
charger at an angle, and then fit 
into place.
The indicator lamp is lit while 
charging and turns off when the 
battery is fully charged.
uCaution
•Do not use the battery charger
•Replace the battery with a new one in the following cases:
•If the indicator lamp blinks or does not light after the battery is inserted correctly
•If the battery starts to run down more quickly even after being charged (the battery may have reached the end of its service life)
tMemo
•The maximum charging time is approximately 240 minutes (it depends on temperature and remaining battery power). Charge in a location where the temperature is between 0°C and 40°C (32°F and 104°F).
Inserting/Removing the Battery
uCaution
•Insert the battery correctly. If the battery is inserted incorrectly, it may not be removed.
•Wipe the electrodes of the battery with a soft dry cloth before inserting.
•Do not open the battery/memory card cover or remove the battery while the power is on.
•Be careful as the camera or battery may become hot after the camera has been used continuously for a long period of time.
•Remove the battery when you will not use the camera for a long time. The battery may leak and damage the camera if left installed during prolonged periods of
•Store the battery in a location where the temperature will remain at or below room temperature. Avoid locations with high temperatures.
•The date and time may be reset if you leave the battery out of the camera for long periods of time. If this happens, set the current date and time again.
1Open the battery/memory
card cover.
Slide the battery/memory card cover unlock lever (1) before
opening the cover. | 1 |
2
Started Getting
29