Installing Options
Available Options
This section describes how to install options.
By installing options, you can improve the printer performance and have an expanded variety of features to use. For the specifications of each option, see Maintenance Guide.
•Before installing options, the machine should be turned off and unplugged for at least an hour. Components inside the machine become very hot, and can cause a burn if touched.
•Before moving the machine, unplug the power cable from the outlet. If the cable is unplugged abruptly, it could become damaged. Damaged plugs or cables can cause an electrical or fire hazard.
•When lifting the machine, use the grips on both sides. The machine could break or cause an injury if dropped.
❒The voltage rating of the connector for options is 24 V DC or less.
Option Installation Flow Chart
We recommend you install multiple options in the following order:
A Attach the paper feed unit (Paper Feed Unit Type 610).
Attach the paper feed unit to the bottom of the printer.
You can attach up to two paper feed unit. Up to 1600 sheets of paper can be loaded.
B Attach the envelope feeder (Envelope Feeder Type 610).
C Install the SDRAM module (Memory Unit Type C 256MB).
D Install the 1394 interface unit, 802.11b interface unit or Bluetooth interface unit.
Install the 1394 interface unit, 802.11b interface unit or Bluetooth interface unit on the controller board.
The 1394 interface unit, IEEE 802.11b interface unit or Bluetooth interface unit cannot be used at the same time.
One of the following can be installed:
• 1394 Interface Unit Type 4510
G1168605A_1.10 | Copyright © 2004, 2005 34 |