The Machine Does Not Print
The Machine Does Not Print
Possible Cause | Solutions |
|
|
|
|
|
|
Is the power on? | Check the cable is securely plugged into the power outlet and the |
|
|
| machine. |
|
|
| Turn on the main power switch. |
|
|
|
|
| 2 |
Is the machine online? | If not, press {fOnline} on the control panel. |
| |
|
|
|
|
Does the Printer key stay | If so, check the error message on the display and take required ac- |
|
|
red? | tion. |
|
|
|
|
|
|
Is there a warning status or | If so, check the error message or warning status on the display and |
|
|
error message on the dis- | take the required action. |
|
|
play? |
|
|
|
|
|
|
|
Can you print a configura- | If you cannot print a configuration page, there maybe a machine |
|
|
tion page? | malfunction. Contact your sales or service representative. |
|
|
| See p.26 “Printing the configuration page” for printing a configu- |
|
|
| ration page. |
|
|
|
|
|
|
Is the interface cable con- | Connect the interface cable securely. If it has a fastener, fasten that |
|
|
nected securely to the ma- | securely as well. |
|
|
chine and computer? | See “Connecting the Machine”, Printer Reference 1. |
|
|
|
|
| |
|
|
|
|
Are you using the correct | The type of interface cable you should use depends on the compu- |
|
|
interface cable? | ter. Be sure to use the correct one. If the cable is damaged or worn, |
|
|
| replace it. |
|
|
| See “Connecting the Machine”, Printer Reference 1. |
|
|
|
|
|
|
Was the interface cable | Connect the interface cable before turning on the machine. |
|
|
connected after the ma- |
|
|
|
chine was turned on? |
|
|
|
|
|
|
|
Is the signal status satisfac- | To check signal status, press the {User Tools/Counter} key, and then |
|
|
tory when using wireless | select [System Settings] using {U} or {T}. On the [Interface Settings], |
|
|
LAN in infrastructure | select [IEEE802.11b], and then select [Wireless LAN Signal] using |
|
|
mode ? | {U}or {T}. If signal quality is poor, remove objects that might |
|
|
| cause interference. |
|
|
| Note |
|
|
| ❒ You can check signal status only when using wireless LAN in |
|
|
| infrastructure mode. |
|
|
|
|
|
|
When using wireless LAN, | Check using the machine's control panel that the SSID is correctly |
|
|
is the SSID correctly set? | set. |
|
|
| See “Interface Settings/IEEE 802.11b (Option)”, Network Guide. |
|
|
|
|
|
|
When using wireless LAN, | Check access point settings when in infrastructure mode. Depend- |
|
|
is the access point correctly | ing on the access point, client access may be limited by MAC ad- |
|
|
set? | dress. |
|
|
| Also, check there are no problems in transmission between access |
|
|
| point and wired clients, and between access point and wireless cli- |
|
|
| ents. |
|
|
|
|
|
|
15