Operating the Heater
Lock
This feature locks the buttons to prevent unintended operation.
Press the up and down buttons to activate and the lamp will glow. Pressing
and holding the up and down will disengage the Lock.
Temp
Control
Function Lock
buttons for two seconds
Sensible Temperature Control
The sensible temperature control feature allows comfortable heating which matches the conditions in the room.
Based on the information collected by the room temperature thermistor when the heating starts, the heating capacity is automatically adjusted to achieve a comfortable heating effect and to reach the temperature setting quickly.
If the Lock is engaged while the unit is operating, all buttons will be disabled except for the ON/OFF button.
If the Lock is engaged while the unit is off, then all buttons will be disabled. The Lock must be disengaged in order to turn the unit on.
Adding Water to the Humidifier
Do not fill the tray while the appliance is in operation. Close the door after filling. The humidifier tray and surrounding area are hot when the appliance is on.
To fill the tray, open the door as shown in the diagram and pour water into the tray using the spout built into the door. The air will be humidified as it passes over the water in the tray.
During operation a small amount of condensation is produced in the flue system and drains into the humidifier tray.
If the water overflows from the water level hole, then do not add any more water.
Humidifier Tray
Max. Fill Line
Access Door
Pull
Filler Spout
Do not force door open too far.
Close door during operation.
Filter Lamp
If the filter lamp flashes | Filter | ON | |||||
during operation, check | |||||||
the air filter for dust. If |
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
dust is present, clean the |
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
filter. See the Care and |
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
Maintenance section. Turn the heater off before cleaning the filter.
Adjusting Air Flow Direction
Do not adjust the air flow louvers while warm air is flowing.
The vertical louvers may be adjusted to move the air flow more to the right or to the left.
Use a screw driver or similar object to bend each louver to the desired position.
Do not bend repeatedly (no more than 5 times) or else the louver will break.
The horizontal louver (which determines the vertical air flow direction) is fixed and cannot be adjusted.
Rinnai Corporation ES38 Manual | 9 |
