Using the Water Smart / Bath Fill Function
Filling the Tub
COLD
ON! COLD
HOT
1.Press the “Water Smart / Bath Fill” button once. The button will illuminate, a tone will sound, and the word “Bath” will appear next to the temperature setting.
2.The voice prompt will announce “The hot water system is ready. Open the hot water tap.” Open the hot water tap. The “In Use” indicator will illuminate on all controllers. The hot water will begin to flow.
3.When the preset volume of water has been produced then
•the water flow will cease
•the “Water Smart / Bath Fill” button will flash
•a tone will sound
•the voice prompt will announce, “Bath fill is complete. Turn off the bath hot water tap and push the Bath Fill button.”
4. Turn off the bath hot water tap and push the Bath Fill button. The water heater will not allow hot water to flow from any source until the “Water Smart / Bath Fill” button is pushed.
The button light will go out and the word “Bath” will disappear from the display.
Setting Controller to Mute
Models MC-91 and MCC-91
To eliminate the beeps when keys are pressed or to turn the beeps back on, press and hold both the and buttons until a beep is heard (approximately 5 seconds).
Setting the Clock
the time which has been set on the
VA Series Outdoor LS Manual | 11 |