Replacing the Battery | Rite Life 394, 393 guide

Replacing the Battery

A low battery condition prevents exposures from occurring. Always Replace The Battery before referring the unit for service.

1.Turn Power Switch “Off” and remove battery access cover by sliding outward.

2.Disconnect old 9-Volt battery from the circuit and discard.

WARNING: Connecting the battery leads backward may cause circuit failure.

3.Connect a replacement 9 Volt Alkaline battery to the circuit—recognizing proper polarity—and insert into the compartment.

4.Reinstall battery access cover and turn power “On.”

Battery Access Cover

9-Volt Alkaline

Battery

18

Image 24

Rite Life 394, 393 manual Replacing the Battery

Contents

393/394 Sensitometer Page FCC CE Declaration Proprietary Notice Limited Warranty Iii Table Of Contents Getting Started Unpacking and Inspection Instrument Description Applying Power Application and Procedures Sensitometer Monitoring For Process Control Log E Curve Selection and Use of Film Processing Procedure Scheduling Sensitometric Control Manual Data Recording Procedure Developer Type Developer vendor identification Daily Plotting of Data on Process Control Record Automatic Data Recording Procedure-Using Densitometer Printing Process Control Records Processor Troubleshooting Speed Index Base+Fog Possible Cause Using the Sensitometer Setting Exposure Color Adjusting Exposure Setting Selecting Single or Dual Exposure 394 only Exposure Setting Exposing Film Important Notes General Maintenance Repair InformationCalibration/Recertification Cleaning the Instrument General CleaningCleaning the Step Tablet Replacing the Battery Technical Specifications WeightPage Page 393-500 Rev. O-4/28/04