Riverstone Networks WICT1-12 Displaying BGP Accounting Information

16-12 Riverstone Networks RS Switch Router User Guide Release 8.0
Basic BGP Tasks BGP Configuration Guide
2. Enable the route-map on incoming traffic from router R1. For example, the following command
applies the route-map ’1’ to routes imported from the peer group ’r1’:
3. Add the interface name to the BGP accounting table. For example, the following command enables
BGP accounting on the interface ’customerA’:
4. Start BGP accounting. For example, to start collecting statistics for the service levels (DSCP values)
of specific traffic routes:
To start collecting BGP traffic statistics for specific traffic routes:
Refer to Section16.3.11, "BGP Accounting Examples," to see detailed example configurations.
Displaying BGP Accounting Information
Use the bgp-actg option with the ip show interfaces command to display BGP accounting information on a
per-interface basis. For example:
bgp set peer-group r1 route-map-in 1 in-sequence 1
ip enable bgp-actg-on customerA
ip bgp-accounting start dscp-accounting
ip bgp-accounting start accounting
rs# ip show interfaces int1 bgp-actg
Interface:int1
Bucket Packets Bytes
0 0 0
1 111 14430