Riverstone Networks WICT1-12 31.3.2 Applying Services Using the MF-Classifier Command

Riverstone Networks RS Switch Router User Guide Release 8.0 31-7
Service Configuration Applying a Service
Here are two examples:
31.3.2 Applying Services Using the MF-Classifier Command
The service apply rate-limit mf-classifier command is used to apply services to interfaces or ports using
MF Classifiers.
To apply services with MF Classifiers, use the following commands:
Here is an example:
! Apply a service to an interface
rs(config)# service userflow1 apply rate-limit acl useracl1 interface userinterface1
! Apply a service to a port
rs(config)# service mktaggregate apply rate-limit acl mktacl port et.3.3
Apply a service
using an MF
Classifier to an
interface or port.
service <name> apply rate-limit mf-classifier interface <name | all> | port
<name> [source-addr-mask <srcadd> destination-addr-mask <dstadd> tos <num>
tos-mask <tosmask> | <source-port | destination-port <port type>
<dns | finger | ftp-cmd | ftp-data | http | https | imap3 | imap4 | lpr | nfs | nntp |
ntp | pop3 | portmapper | rexec | rlogin | rshell | snmp | smtp | telnet | tftp |
x11>>]
! Apply the service aggregate1 to an interface
rs(config)# service aggregate1 apply rate-limit mf-classifier interface interface1
source-addr-mask 10.10.10.80 source-port telnet tos 2