17-84 Riverstone Networks RS Switch Router User Guide Release 8.0
Configuring L2 Tunnels MPLS Configuration
In Figure17-19, ports gi.6.2, gi.2.1, and gi.5.1 on R1, port gi.15.1 on R3, and port gi.12.2 on R5 are mapped to
customer ID 10. The customer IDs are mapped to VC labels that are distributed via LDP. The tunnel LSPs can use
either LDP or RSVP as the signaling protocol; configuration commands for RSVP tunnel signaling are shown for this
example.
Note The ports that are mapped to a single customer ID number must be either all trunk
ports or all access ports. The example shows configurations for transporting
802.1q traffic.
Timesaver Click on the router name (in blue) to see the corresponding configuration.
Figure 17-19 Tunneling of virtual circuits based on ports (RSVP tunnel)
Tunnel LSPs:
Virtual Circuit based on ports
R3
R1 R2
R5
R6
R4
gi.6.2
gi.2.1
gi.5.1
Customer ID 10: Customer ID 10:
Customer ID 10:
gi.15.1
gi.12.2
gi.4.1 gi.14.1 gi.14.2 gi.12.2
gi.12.1
gi.3.1
gi.3.2
gi.13.1
gi.13.1gi.4.1
gi.5.1
gi.4.2
gi.4.2