Riverstone Networks WICT1-12 31.2.3 Per-Flow Rate Limiting Service

Riverstone Networks RS Switch Router User Guide Release 8.0 31-5
Service Configuration Creating a Service
Here is an example:
31.2.3 Per-Flow Rate Limiting Service
Per-flow rate limiting is enabled on the RS by default. If aggregate rate limiting is enabled on a particular line card,
per-flow rate limiting policies can not be applied to ports on that line card.
To create a per-flow rate limiting service, use the following command:
Here is an example:
! Create a flow-aggregate service, limiting an aggregate flow to 10 million bps, drops packets if the rate is exceeded
! and distributed across 10 flows
rs(config)# service testaggregate create rate-limit flow-aggregate rate 10000000
exceed-action drop-packets distribute-among 10
Create a per-flow
rate limiting service. service <name> create rate-limit per-flow rate <rate> [exceed-action <drop-packets | set-priority-low | set-priority-medium |
set-priority-high> | time-select <num>]
! Create a per flow service, limiting one flow to 1 million bps and drops packets if the rate is exceeded
rs(config)# service user1flow create rate-limit per-flow rate 1000000 exceed-action
drop-packets