Manual tuning - FM
1.Fully extend the telescopic aerial. The aerial should be fully extended and positioned vertically for optimum reception.
2.Press the On / Standby button to switch on your sound system.
3.Press the FM button to select the FM band.
4.Repeatedly press and release the Tuning Up or Down buttons to tune to a station. The frequency will change in steps of 50kHz.
If the radio is tuned to a station of sufficient signal strength with RDS information present, then the display may change to show the station name.
5.When the waveband end is reached the radio will recommence tuning from the opposite waveband end.
6.Adjust the Volume to the required setting.
7.To switch off your sound system press the On / Standby button.
Note:
If you find that FM reception is poor, try repositioning the Telescopic aerial fully extend and position vertically for optimum reception.
If you find that an FM broadcast has a lot of background hiss, this may often be reduced by setting the radio into Mono reception mode for the current FM station. Please refer to the section "Stereo / Mono setting - FM" on page 36 for further details.
2,7
3
4
4
6 6
15
