OPERATION
ADJUSTING GAIN
To adjust the gain setting, turn the amplifier gains all the way down. Turn the source unit volume up until distortion is audible and then turn it down a bit until the distortion is inaudible. Next, turn the amplifier gain setting until once again distortion is audible and then back it down until the distortion is inaudible. Rockford Fosgate source units do not distort, so the volume can be used at maximum setting.
NOTE: For a more in depth setting procedure, contact Rockford Technical Support.
ADJUSTING CROSSOVER FREQUENCY
The crossover frequency can be adjusted between
Turn the crossover adjustment knob all the way down. With the system playing, turn the crossover adjustment knob up slowly until the desired crossover point is achieved.
INFRASONIC FILTER
Placing the switch to "ON" engages the infrasonic filter limiting the amount of low frequency information going to the woofer. Set this to your personal preference while listening to the system one way, then the other.
COLOR OPTIONS
Personalize your Type RF amplifier by |
|
changing the top and corner plastics to | Screw |
different colors. Available through our web | |
site or local retailer. |
|
The corners can be changed by removing the screw at the bottom, pull the old corner up and out, install the new corner, and reinstall the screw.
The top plastic requires you to remove the cover plate from the amplifier. Do this by removing the four (4) 3/16" allen screws from each corner.
Remove the screw holding the top plastic in place, pull the old top up and out, install the new top, ensure the top fits into the notches at the back, and reinstall the screw. Reinstall the cover plate and the four (4) allen screws.
Allen
Screw
8
