![ACCESSORIES](/images/new-backgrounds/23972/2397223x1.webp)
ACCESSORIES
PUNCH Capacitors
Maintain the power you need to your Punch Amplifier.
PUNCH Install Kits
A variety of install kits are available to help you install your Punch amplifier like a professional.
Para-Punch Remote Bass Control
This adds an adjustable center frequency control with the adjustable boost control.
See our web site for other accessories to help you get the most out of your system.
www.rockfordfosgate.com
SPECIFICATIONS
MODEL- PUNCH |
| P325.1 | P600.1 bd | ||||
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts |
| ||||||
4 | Load Mono |
| 175 Watts x 1 |
|
| 325 Watts x 1 | |
|
| ||||||
2 | Load Mono |
| 325 Watts x 1 |
|
| 600 Watts x 1 | |
Dimensions: | Height |
| 2.1" (5.33cm) |
|
| 2.1" (5.33cm) | |
|
| Width |
| 11" (27.94cm) |
|
| 11" (27.94cm) |
|
| Length |
| 11.7” (29.72cm) |
|
| 13.7" (34.80cm) |
Amplifier Fuse Rating (Amp/Type) |
| (1) 40A / ATC |
|
| (2) 30A / ATC | ||
Battery Fuse Rating (Amp) External |
| 40A |
|
| 60A | ||
(Not Supplied) |
|
|
|
|
|
| |
|
|
|
|
|
| ||
|
| >80dB | |||||
| Crossover Slope |
| 12dB/octave Butterworth | ||||
| Crossover Frequency (P325.1) |
| variable from 40Hz to 400Hz | ||||
| Crossover Frequency (P600.1 bd) |
| variable LP (low pass) from 35Hz to 250Hz | ||||
| Frequency Response (P325.1) |
| 20Hz to 20kHz ±0.5dB | ||||
| Frequency Response (P600.1 bd) |
| 20Hz to 250Hz ±3dB | ||||
| Bandwidth (P325.1) |
| 20Hz to 200kHz ±3dB | ||||
| Slew Rate |
|
| 30 Volts/µS |
| ||
| IM Distortion (IHF) | <0.05% |
| ||||
| Signal Voltage Adjustment Range |
| Variable from 150mV to 4V (RCA Input) | ||||
| Protection (P325.1) | NOMAD - Internal | |||||
|
|
| circuitry limits power in case of overload, plus short | ||||
|
|
| protection.Thermal switch shuts down the amplifier | ||||
|
|
|
| in case of overheating. | |||
| Protection (P600.1 bd) | Short circuit protection shut downs the amplifier in | |||||
|
|
| case of very low impedance or shorted speaker wires. | ||||
|
|
| Thermal switch shuts down the amplifier in case of overheating. | ||||
| Equalization (45Hz Punch Bass) |
| Variable from 0dB to +18dB @ 45Hz | ||||
| Input Impedance |
| 10k ohms |
| |||
| Infrasonic Filter (P600.1 bd) |
| Selectable 12dB/Octave, |
These specifications are Amplifier Power Standard
Specifications subject to change without notice
12