OPERATION
ADJUSTING CROSSOVER FREQUENCY (P325.1)
Placing the switch in the HP position sets the amplifier to the High Pass mode, enabling frequencies above the
Placing the switch in the AP position sets the amplifier to the All Pass mode, preventing any crossover adjustment, allowing all frequencies to pass.
Placing the switch in the LP position sets the amplifier to the Low Pass mode, enabling frequencies below the
Turn the crossover adjustment knob all the way down.With the system playing, turn the crossover adjustment knob up slowly until the desired crossover point is achieved.
ADJUSTING CROSSOVER FREQUENCY (P600.1 bd)
The crossover frequency can be adjusted between
Turn the crossover adjustment knob all the way down.With the system playing, turn the crossover adjustment knob up slowly until the desired crossover point is achieved.
INFRASONIC FILTER (P600.1 bd)
Placing the switch to "ON" engages a 28Hz infrasonic filter limiting the amount of low frequency information going to the woofer. Set this to your personal preference while listening to the system one way, then the other.
NOTE: We recommend using the infrasonic filter when using small diameter woofers with this amplifier.
10