Roland owner manual Assembling the F-50, Check the Parts, Assembly Procedure, Introduction

Introduction

Assembling the F-50

•Make sure that another person is on hand to help with the assembly and setup.

•To move the piano, lift it carefully—all the while keeping it level. Be very careful, when you assemble and move

the piano, to make sure that you do not drop it on your hands or feet.

•Always carry out this procedure with the F-50 lying horizontally, with the rear panel facing down.

•Should you the screws used in assembling the stand or those used for attaching the music stand, make sure to put them in a safe place out of children’s reach, so there is no chance of them being swallowed accidentally.

■Check the Parts

Before you begin assembling the F-50, check that all the parts were supplied.

You will also need to have a Phillips screwdriver.

1F-50

2Center Board

3Side panel right and left

Rear

(Right)

Front

Cross section

Rear

(Left)

Front

4Screw x 8

5Cap x 8

(and 4 spare caps)

■Assembly Procedure

•At first, assemble the entire unit in a temporary fashion, without really tightening the screws.

Then, after checking the overall alignment of the boards (and gently shifting certain parts where necessary), go around and tightly fasten each of the screws.

•Be careful when assembling the F-50, so as to avoid scratching the side panels.

When securing the screws, lay the entire unit sideways with the rear side of the F-50 at the bottom.

1.To avoid scratching the instrument, remove the F- 50’s packing sheet and spread it out where the stand is to be assembled.

If you do not have the packing sheet on hand, then use any soft, non-scratching sheet instead.

2.Using the screws, secure one of the side panels to the F-50 and the center board (four locations).

F-50

		Screws
Center Board	Side panel	Side with
	(Right)
		rounded
		corners
		facing out

3.Use the screws to secure the other side panel to the F-50 and the center board (four locations).

Screws

6